D-MAX DSC-300Se5, Руководство пользователя

Страница: 24 / 45

22
■ How to set TRACE
Move to [SET] after pressing „ F/N KEY ‟
F/F KEY Check
– Control the scenes that you want to save a
joystick after the message “Set Trace: OO%” on the middle of
the screen.
If you are done with above action, move to [SAVE] with
„ F/N
Key
„
It goes to a higher menu after saving the data with the
message
“Save TRACE”, if ‟ F/F KEY is pressed.
16. ALRAM CHANNEL ON/OFF
■ What is the ALARM function? : It uses a sensor and
operates to observe the location of the camera which
is memorized previously in the situation of the
warning signal or trespassers.
- CH On/Off: Alarm Input
– Each channel can be ON/OFF
- Alarm Relay : It can be set
„On‟ or „Off‟ when ALARM
OUTPUT PORT detects the alarm.
- Active Alarm: It can be selected to either ACTIVE OPEN or
ACTIVE CLOSE by the way of tangency.
ACTIVE OPEN: Alarm activates when Alarm input is set
“OPEN”
ACTIVE CLOSE: Alarm activates when alarm input is set
“CLOSE”.
- Resume Time Set:
When alarm activates during SWING, GROUP and TOUR,
camera moves to the place and this function allows you to set
dwell time(1~180sec) After designated time the camera goes
back to previous function(SWING, GROUP or TOUR).
If you stop the function while in use by joystick when Alarm is
not connected, Swing, Group or Group will be functioned after
the time you set.
Press SWING, GROUP or TOUR key if you want to put it to
stop completely. .
( Stopping the function by joystick will affect the SET function)
<< CAMERA SETUP p3 >>
16. ALARM CH ON/OFF PAGE
17. ALARM PRESET SET PAGE
18. Select Alarm : Sensor
19. Motion on/off : Off
20. Motion Detection Set :
21. PRIVACY ZONE SET :
- NEXT PAGE