2Mega TVI & AHD Hybrid
Mini Speed Dome Camera User manual
17
3. DIP switch setting
3.1. DIP
Switch
setting
<S1>
SET No#1~7 DIP SWITCHES FOR CAMERA
ADDRESS.
SET INIT DIP SWITCHES FOR CAMERA
PROTOCOL & BAUD RATES. (This part is each
address of camera)
SET 8th DIP SIWTCH FOR NTSC/ PAL SIGNAL.
<POWER LED>
It shows the status of Power On/Off.
Green LED is On while power is alive.
In the status of operation, red LED is
off.
<S2>
- Termination Resistor (DIP S2/SW1)
→ Turn the last camera on the data line as a switch to
turn on/off the terminal resistor on.
Turn the DIP SW of some of the farthest cameras on
in the case of the data lines distributed to several
directions.
(* The default is off.)
- Address / Initial Select (DIP S2/SW2)
→ Set ADDRESS DIP SW in the status of ADDRESS
(* Reference to next page *)
(.*** The first default is ADDRESS.**)
Set the communication speed (baud rates) and Protocol
(Demand for the technical inquiry) up in the state of the
INITAIL.
-Select TVI or AHD output (DIP S2/SW 3)
→ TVI : TVI output, AHD : AHD output
- Power On/Off (DIP S2/SW 4)
→ Set DIP SW only in the status of Power off. Then turn
on the power after setting DIP SW.
