D-Link xStack DGS-3120-24PC, Справочное руководство CLI

Страница: 628 / 1150

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
623
Chapter 61 Multicast Listener
Discovery Protocol (MLD)
Command List (RI Mode
Only)
config mld [ipif <ipif_name 12> | all] {query_interval <sec 1-31744> | max_response_time <sec 1-
25> | robustness_variable <value 2-7> | last_listener_query_interval <sec 1-25> | version
<value 1-2> | state [enable | disable]}(1)
show mld {ipif <ipif_name 12>}
show mld group {ipif <ipif_name 12> | group <ipv6addr>}
61-1 config mld
Description
This command is used to configure MLD on the Switch.
Format
config mld [ipif <ipif_name 12> | all] {query_interval <sec 1-31744> | max_response_time
<sec 1-25> | robustness_variable <value 2-7> | last_listener_query_interval <sec 1-25> |
version <value 1-2> | state [enable | disable]}(1)
Parameters
ipif - Specify the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used for this configuration. This name can be
up to 12 characters long.
all - Specify that all the IP interfaces to be used.
query_interval - Specify the time in seconds between general query transmissions.
<sec 1-31744> - Enter the query interval time. This value must be between 1 and 31744
seconds. The default value is 125.
max_response_time - Specify the maximum time in seconds to wait for reports from members.
<sec 1-25> - Enter the maximum response time here. This value must be between 1 and 25
seconds. The default value is 10.
robustness_variable - Specify the permitted packet loss that guarantees MLD.
<value 2-7> - Enter the robustness variable here. This value must be between 2 and 7. The
default value is 2.
last_member_query_interval - Specify the maximum Response Time inserted into the Multicast
Address Specific Query sent in response to Done Group messages, which is also the amount
of time between Multicast Address Specific Query messages.
<value 1-25> - Enter the last member query interval value here. This value must be between
1 and 25. The default value is 1.
version - Specify the MLD version.
<value 1-2> - Enter the MLD version number. This value must be between 1 and 2. The
default value is 2.
state - Specify the MLD state on a router interface.
enable - Specify that the MLD state will be enabled.