6
D-Link Systems, Inc.
DNS-G120 Install Guide
Hardware Installation
Installing the Hardware
It is required that an Ethernet cable is used during initial setup. Once your
wireless confi guration is set, you may disconnect the Ethernet cable and
reboot the DNS-G120 to connect to your wireless network.
Attach the provided Ethernet cable to the Ethernet port on the rear panel.
1
Attach the other end of the Ethernet cable to an available Ethernet port on
your router or switch.
2
Plug the AC adapter into the receptor located on the back of the DNS-G120.
Plug the other end of the AC Adapter into a power strip or wall outlet.
3
4
Attach your USB drive(s) to the USB port(s) located on the rear panel of the
DNS-G120. The USB LED on the front panel will blink until the drive has
been installed. Once the USB LED is solid green, your USB drive is ready
for use.