802.11 b/g Access Point Command Line Interface Manual
11
set remoteAP
Set Remote AP's Mac Address
set remoteAP <xx:xx:xx:xx:xx:xx>
set autochannelselect
Set Auto Channel Selection to enable or disable
set autochannelselect [disable:enable]
set rate
Set Data Rate
set rate [best:1:2:5.5:6:9:11:12:18:24:36:48:54]
set beaconinterval
Modify Beacon Interval 20-1000
set beaconinterval [20-1000]
set dtim
Set Delivery Traffic Indication Message Beacon Rate. Default is 1
set dtim [1-255]
set fragmentthreshold
Set Fragment Threshold
set fragmentationthreshold [256-2346]
set rtsthreshold
Set RTS/CTS Threshold in bytes
set rtsthreshold [256-2346f]
set power
Set Transmit Power in predefined increments
set power [full:half:quarter:eighth:min]
set roguestatus
Set Rogue AP status
set roguestatus [disable: enable]
set roguebsstypestatus
Set Rogue AP BSS type status
set roguebsstypestatus [disable: enable]
set roguebsstype
Set ROGUE AP BSS Type
set roguebsstype ['apbss' | 'adhoc' | 'both' ]
set roguesecuritystatus
Set Rogue AP Security Type status
set roguesecuritystatus [disable: enable]
set roguesecurity
Set ROGUE AP Security Type
set roguesecurity
set roguebandselectstatus
Set Rogue AP Band Select status
set roguebandselectstatus [disable: enable]
set roguebandselect
Set ROGUE AP Band Select
set roguebandselect
set radius2ndstate
Set the second RADIUS Mode
set radius2ndstate [disable: enable]
set SuperG
Enable or Disable Super G Features
set SuperG [disable: enable]
set wlanstate
Select the operational state of wlan: enabled or disabled
set wlanstate [disable: enable]
set shortpreamble
Set Short Preamble
set shortpreamble [disable: enable]
set wirelessmode
Used to select the wireless mode of operation for the AP: 11g, 108g
set wirelessmode [11g:
108g dynamic]
set 11gonly
Only 802.11g clients will be Allowed to connect to this BSS
set 11gonly [disable:enable]
set antenna
Set Antenna selection of 1, 2, or best
set antenna [1:2:best]
set aging
Set Aging Interval
set aging <seconds>
set channel
Select Radio Channel of Operation
set channel [1:2:3:4:5:6:7:8:9:10:11]
set diap
Enable or Disable DIAP
set diap [disable: enable]
set eth2wlan
Enable or Disable the Eth2Wlan Broadcast packet filter feature
set eth2wlan [0:1]
Explanation: 0=disable:1=enable
set sta2sta
Set wireless STAs to wireless STAs connect state (WLAN Partition)
set sta2sta [disable: enable]
set eth2sta
Set ethernet to wireless STAs connect state
set eth2sta [disable: enable]
set ratecontrol
Enable/Disable supported datarate
set ratecontrol [disable:enable]
set supportrate
Modify supported datarate(bit mask)
set supportrate
set ifping
Set ping Allowed to enable or disable
set ifping [disable: enable]
set MulticastRateControl
Enable or Disable Multicast Rate Control
set MulticastRateControl [0:1]
Explanation: 0=disable:1=enable
set MulticastRateIndex
Set Multicast Rate Index
set MulticastRateIndex [0-11]