DVG-5402G/GF
Wireless AC1200 MU-MIMO Dual Band
Gigabit Router with Fiber WAN Port, 3G/LTE Support, 2 FXS
Ports, and USB Port
User Manual
Configuring via Web-based Interface
If the IPsec tunnel operates over IKEv2 (
2
is selected from the
IKE version
list in the
The First
Phase
section), you can create several subnets.
Figure 111. The page for adding an IPsec tunnel. The window for adding a tunneled network.
In the opened window, you can specify the following parameters:
Parameter
Description
Local network
A local subnet IP address and mask.
Remote subnet
A remote subnet IP address and mask.
MTU
The maximum size (in bytes) of a non-fragmented packet. The field is
displayed when the
Manual
value is selected from the
TCP MSS
drop-down list in the
General Settings
section.
To edit fields in the
Tunneled Networks
section, select the relevant line in the table. In the
opened window, change the needed parameters and click the
SAVE
button.
To remove a subnet, select the checkbox located to the left of the relevant line in the table and click
the
DELETE
button (
). Also you can remove a subnet in the editing window.
After configuring all needed settings for the IPsec tunnel, click the
APPLY
button.
To edit the parameters of an existing tunnel, in the
Tunnels
section, select the relevant tunnel in the
table. On the opened page, change the needed parameters and click the
APPLY
button.
To disconnect an existing tunnel and establish it again, select the checkbox located to the left of the
relevant line in the table and click the
RECONNECT
button.
To remove an existing tunnel, select the checkbox located to the left of the relevant line in the table
and click the
DELETE
button (
). Also you can remove a tunnel on the editing page.
To disable VPN tunnels based on IPsec protocol, move the
Enable
switch to the left.
Page
137
of 311
