LED
Color
Status
Description
Power /
Status
Orange/
Green
Solid Orange
Device during power-портов
on process.
Solid Green
Completion of power
on.
Blinking
Orange
Device is crashed and
under recovery mode.
Blinking
Green
The system is
defective, such
firmware upgrades fail.
Light Off
The device is power-портов
off.
2.4GHz/
5GHz
WLAN
Green
Steady Green The link is good.
Blinking
Green
There is activity on this
port.
Light Off
No link.
USB
Green
Solid Green
The link is good.
Blinking
Green
There is activity on this
port.
Light Off
No link.
TX/RX
Status
Green
Light Off
No link.
Solid Green
Link present.
Blinking
Green
Port is sending or
receiving data.
LINK
Speed
Green/
Orange
Light Off
Port is operating at
10Mbps.
Solid Green
Port is operating at
100Mbps.
Solid
Orange
Port is operating at
1000Mbps.
Table 2. Device Status LED Descriptions
DSR-1000AC Default Interface Settings
Ethernet
Interface
Interface
Type
IP Address
Web-Based
Management
LAN(1-портов4) /
WLAN
Static IP
192.168.10.1/24 Enabled
WAN1
DHCP Client 0.0.0.0/0
Disabled
WAN2
(Configurable
port)
DHCP Client
(default)
0.0.0.0/0
Disabled
Static IP
(When it’s
configured
as DMZ)
172.17.100.254/
24
Disabled
Table 3. Default Interface Settings
Note
: D-портовLink Wireless AC Services Router only
allow Web GUI access from LAN and WLAN
interfaces by default for security reason. The
WAN2 is a configurable port which support
various and advanced scenario applications.
When WAN2 port is configured as DMZ port,
the IP address will be changed to
172.17.100.254.
Installing and Connection
This chapter describes how to install a DSR-портов
1000AC device in a standard 19-портовinch equipment
rack and how to connect cables and power to
the device.
Before You Begin
Observe the following precautions to help
prevent shutdowns, equipment failures and
injuries:
-портов Before installation, always check that the
power supply is disconnected.
-портов Ensure that the room in which you operate the
device has adequate air circulation and that the
room temperature does not exceed 40
º
C
(104
ºF
).
-портов Allow 1 meter (3 feet) of clear space to the
front and back of the device.
-портов Do not place the device in an equipment rack
frame that blocks the air vents on the sides of
the chassis. Ensure that enclosed racks have
fans and louvered sides.
-портов Correct these hazardous conditions before any
installation: moist or wet floors, leaks,
ungrounded or frayed power cables, or missing
safety grounds.
Installing Equipment
You can mount the DSR-портов1000AC device into a
standard 19-портовinch equipment rack. To install an
appliance into a rack:
1. Attach the mounting brackets to each side of
the chassis as shown in figure 3 and secure
them with the screws provided.
Figure 3. Attaching Rack Mount Brackets
D-портовLink Wireless AC Services Router
