D-Link DSL-380T, Руководство пользователя, Страница: 34 / 66

DSL-380T ADSL Modem User Guide
24
and then granting Internet access to the computer requesting the connection. The connection software requires the user
to enter the User Name and Password for the ISP account. This information is stored on the computer, not in the
Modem.
Follow the instructions below to configure a Bridged connection for the WAN interface.
To configure a Dynamic IP Address connection, perform the steps listed below. Some of the settings do not need to be
changed the first time the device is set up, but can be changed later if you choose. See the table below for a description
of all the settings available in this window.
1. Click the Bridge Mode radio button in the WAN Settings section in the middle of the window.
2. The settings under ATM VC Setting at the top of the window should not be changed unless you have been
instructed to change them. However, if you are instructed to change the
VPI or VCI values, type in the values
assigned for your account. Leave the Virtual Circuit setting at the default ( Enabled ) value for now.
3. Under the Bridge Mode heading, choose the Connection Type from the pull-down menu. This defines both
the connection type and encapsulation method used for your ADSL service. The available options are 1483
Bridged IP LLC and 1483 Bridged IP VC-Mux. If you have not been provided specific information for the
Connection Type , leave the default setting.
4. Most users will not need to change ATM settings. If this is the first time you are setting up the ADSL
connection it is recommended that you leave the
Service Category settings at the default values until you have
established the connection. See the table on page 25 for a description of the parameters available for ATM
traffic shaping.
5. When you are satisfied that all the WAN settings are configured correctly, click the Apply button.
6. The new settings must be saved and the Modem must be restarted for the settings to go into effect. To save and
reboot the Modem, click on the
Tools directory tab and then click System . Next click the Save and Reboot
button in the lower half of the System Settings window.
7. Click OK when the following “Save and restart?” dialog box opens.
8. The Modem will save the new settings and restart. Upon restarting the Modem will automatically establish the
WAN connection.