5
D-Link DPR-1260 Quick Install Guide
Connect an Ethernet cable to the Ethernet connector located on the
Print Server’s back panel and attach it to the network.
Note:
It is required that an Ethernet cable is used during initial
setup. Once your wireless configuration is set, you may disconnect
the Ethernet cable and begin communicating wirelessly with your
DPR-1260.
Attach the external power supply to the DC power input connector
located on the Print Server’s bottom panel and connect it to a power
outlet or power strip.
The factory default IP address of the DPR-1260 is 192.168.0.10.
The IP address of the DPR-1260 must be in the same range as your
network. You can change the IP address of the DPR-1260 to match
the IP address scheme of your existing network. To access the Print
Server’s Web configuration interface, assign an IP address on one
of the wired PCs on your network to the same IP scheme as the
Print Server.
Note:
Some printer software features may not work while connected
to the print server such as ink level display.
Installation
