DPN-1021G
Quick Installation Guide
CONNECTING TO PC
!
Invisible laser radiation may be emitted from the end of the fiber and/or
from
DPN-1021G
. Take all necessary precautions to avoid unnecessary
exposure to this radiation.
1. Connect an Ethernet cable between the Ethernet port of your PC and the
10/100/1000Base-T port (
LAN1
) or 10/100Base-TX port (
LAN2
).
2.
To connect the device to a fiber optic line
: connect the fiber optic cable
to the PON port in the bottom panel of the gateway. Make sure that center
conductor of the cable is inserted directly into the center of the PON
connector. Secure the cable by carefully pushing the fiber connector onto
the PON connector until tight. Be careful not to over-tighten the
connector or you may damage either the cable or the device.
3.
To connect the device to an Ethernet line
: in the web-based interface of
the gateway, select the gateway's LAN port that will be used as the WAN
port and create an Ethernet WAN connection. Then connect an Ethernet
cable between an available Ethernet port of the gateway and the Ethernet
line.
!
Please connect the gateway to the ISP's Ethernet line only after setting
the WAN port and creating the Internet connection.
4. Connect a phone cable between the FXS port of the gateway and the
phone.
5. Connect the power cord to the power connector port on the back panel of
the gateway, then plug the power adapter into an electrical outlet or power
strip.
6. Turn on the gateway by pressing the
ON/OFF
button on its back panel.
7. Wait for several minutes. When the device receives all needed settings,
the
GPON
LED will stop blinking and will light solid green. When the
Internet connection is established, the
Internet
LED will light solid
green.
Now you should configure your PC to obtain an IP address automatically (as
DHCP client).
4
