D-Link DIR 635 B3, Руководство пользователя

Страница: 23 / 97

19 D-Link DIR-635 User Manual
Section 3 - Configuration
Select
PPPoE (Username/Password)
from the drop-down menu.
Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic .
Enter the IP address (Static PPPoE only).
Enter your PPPoE user name.
Enter your PPPoE password and then retype the password in the next
box.
Enter the
ISP Service Name
(optional).
Select either Always-on , On-Demand , or Manual .
Enter a maximum idle time during which the Internet connection is
maintained during inactivity. This function does not apply if you have
selected
Reconnect Mode
as
Always on
.
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE only).
You may need to change the MTU (Maximum Transmission Unit) for optimal performance with your specific ISP. 1492 is
the default MTU value.
The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless required by your ISP. You can use the
Clone Your PC’s
MAC Address button to replace the Internet port’s MAC address with the MAC address of your Ethernet card.
My Internet
Connection:
Address Mode:
IP Address:
User Name:
Password:
Service Name:
Reconnection Mode:
Maximum Idle
Time:
DNS Addresses:
MTU:
MAC Address:
Internet Setup
PPPoE (DSL)
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.