69
D-Link DIR-615+ User Manual
Section 4 - Configuration
IP Filter Create/Edit
General Settings
Enable rule:
Toggle this switch to enable the rule.
Name:
Specify a name for the rule. This name is for reference only and does
not affect functionality.
Action:
Choose the action to be taken when the rule is triggered. Choose
Allow
or
Deny
.
Protocol:
Choose which protocol to which the rule will apply. Choose from
TCP/
UDP
,
TCP
,
UDP
,
ICMP
, or
<All>
IP version:
Choose if the rule should apply to
IPv4
or
IPv6
.
Destination IP Address
Set as:
Choose
Range or single IP address
to enter a specific IP address or
ranges for the destination filter. Choose
Subnet
to specify a subnet
only.
Start/End IPv4/
IPv6 address:
If you have selected
Range or single IP address
, specify an IP address
range for the destination filter. To enter a single address, use only the
Start IPv4/IPv6 address
field and leave the
End IPv4/IPv6 address
field blank.
Subnet IPv4/IPv6
address:
If you have selected
Subnet
, specify the destination subnet to filter.
Protocol:
Indicates to which protocol(s) the filter applies.
Source IP address:
Indicates the IP address range and port(s) to which the filter applies.
