DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch Hardware Installation Guide
17
2.6 Select
Terminal
keys for
Function
,
Arrow
, and
Ctrl
keys. Ensure that you select Terminal keys (not
Windows keys).
3. After you have correctly set up the terminal, plug the power cable into the power receptacle on the back of the
Switch. The boot sequence appears in the terminal.
4. After the boot sequence completes, the console login screen displays.
5. If you have not logged into the command line interface (CLI) program, press the
Enter
key at the User name
and password prompts. There is no default user name and password for the Switch. The administrator must
first create user names and passwords. If you have previously set up user accounts, log in and continue to
configure the Switch.
6. Enter the commands to complete your desired tasks. Many commands require administrator-level access
privileges. Read the next section for more information on setting up user accounts. See the
DGS-3700 Series
CLI Manual
on the documentation CD for a list of all commands and additional information on using the CLI.
7. When you have completed your tasks, exit the session with the logout command or close the emulator
program.
8. Make sure the terminal or PC you are using to make this connection is configured to match these settings.
If you are having problems making this connection on a PC, make sure the emulation is set to VT-100. You will be
able to set the emulation by clicking on the
File
menu in you HyperTerminal window, clicking on
Properties
in the
drop-down menu, and then clicking the
Settings
tab. This is where you will find the
Emulation
options. If you still do
not see anything, try rebooting the Switch by disconnecting its power supply.
Once connected to the console, the screen below will appear on your console screen. This is where the user will enter
commands to perform all the available management functions. The Switch will prompt the user to enter a user name
and a password. Upon the initial connection, there is no user name or password and therefore just press “enter” twice
to access the command line interface.
DGS-3700-12G Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.B023
Copyright(C) 2009 D-Link Corporation. All rights reserved.
UserName:
Figure 4- 1. Initial screen after first connection
NOTE:
When you use HyperTerminal with the Microsoft® Windows® 2000 operating
system, ensure that you have Windows 2000 Service Pack 2 or later installed. Windows
2000 Service Pack 2 allows you to use arrow keys in HyperTerminal's VT100 emulation.
See www.microsoft.com for information on Windows 2000 service packs.
Содержание DGS-3700 Series
Страница 60: ......
