D-Link DCS-8000LH, Быстрое руководство по установке

Страница: 4 / 74

DCS-8000LH
4
E
N
G
LI
S
H MOUNTING THE CAMERA
Please refer to the steps below to assist you with mounting the camera. It is recommended that you
configure the camera before mounting.
2
3
1
4
5
6
Step 1:
Place the camera base where you want to position the camera
and use a pencil to mark the holes. Make sure they are aligned
and be careful not to move the base when marking the second
hole.
Step 2:
Depending on the material of the wall or ceiling, use proper tools
to drill two holes 25mm deep with a 6mm drill bit where you
marked. If the wall is made out of concrete, drill the holes first,
then insert the plastic anchors to support the screws.
Step 3:
Place the baseplate over the holes that are in the wall. Make
sure to align the baseplate holes with the holes in the wall. Use
the supplied screws to attach the baseplate to the surface of the
wall.
Step 4:
Place the camera into the mount. Make sure that the power port
in the back is exposed to the hole in the mount. Plug the USB
power cable into the camera. Make sure it is plugged in all the
way.
Step 5:
Align the slash marking on the base to the same slash marking
on the camera base. Press camera mount onto the base.
Step 6:
Twist the camera mount slightly clockwise to the right to lock
it into place. Using a coin or flathead screwdriver, tighten the
screw on the left side of the camera mount to lock the camera
angle into place.