D-Link DCS-6620G - Network Camera, Быстрая установка, Страница: 5 / 16

D-Link Systems, Inc.
DCS-660G Install Guide Hardware Installation
Hardware Installation
Connect the Ethernet Cable
Connect one end of the Ethernet cable to the
network cable connector located on the back
panel of the DCS-6620G, and attach the other
end to a router, switch, or gateway on the
network.
If you connect this camera directly
to a PC, you will need a cross-over
Ethernet cable. If you plug the camera into
a hub or router, you will be able to use
the cable included with your camera.
Attach the External Power Supply
Attach the external power supply to the DC
power input connector located on the
backpanel of the DCS-6620G (labeled DC
12V), and connect it to an AC power outlet.
Power source is confirmed
when the LED Power Indicator
on the Network Camera is illuminated.
Both the red and green LEDs will flash alternately
and only the red LED will remain lit. The green
LED will not come on until you have configured
your camera.
Attach the Antennas
Attach the two antennas to the connectors
located on the back panel of the DCS-6620G.
It is required that an Ethernet cable
is used during initial setup. Once
your wireless configuration is set, you may
disconnect the Ethernet cable and reboot
your camera to connect to your wireless
network.