2
4
5
1
2
3
Ⅲ.
Fitting instructions for camera
1 Camera mounting platform
2 Terminal block assembly
3 Cable conduits PGB13.5 x 2
4 Captive retainning 1/4” Screws x 3
5 Ground wire
Fig.3
(G)
(F)
(A)
(B)
(C)
(D)
(C)
(E)
(G)
(J)
(I
)
(H)
1. Unscrew the 3 captive
retaining screws
(C) and remove the
housing cover
(A) from the
housing base
(B).
2. Release the 4 keyhole
screws
(F) and then slide and withdraw the
camera platform
(G)
from the
housing base
(B).
3. Mount the
camera
(H) onto the
camera
platform
(G) using the
1/4” UNC screw
(I) supplied,
ensuring that the
insulation pad
(J) is mounted between the platform and the camera.
Always check if the camera is firmly attached to the platform.
4. Connect the camera power cable to the
rear terminal block
(E) through the first
cable conduit
(D).
5. Connect the video cable to the camera through the second
cable conduit
(D).
IMPORTANT NOTE:
ALWAYS UNPLUG THE TOP SECTION OF THE EARTH WIRE FROM THE BASE WIRE WHEN
DISASSEMBLING THE HOUSING. REMEMBER TO PLUG THE TOP AND BOTTOM TOGETHER
AGAIN WHEN REASSEMBLING THE HOUSING.