DAP-1620
AC1300 MU-MIMO Wi-Fi Range Extender
User Manual
Installation and Connection
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (configure the wireless network, change the operating mode of the device,
configure MAC-address-based filtering, etc.).
Start a web browser (see the
section, page 14). In the address bar of the web
browser, enter the IP address of the extender (by default, the following IP address is specified:
192.168.0.50
). Press the
Enter
key.
Figure 22. Connecting to the web-based interface of the DAP-1620 device.
!
If the error “
The page cannot be displayed
” (or “
Unable to display the page
”/“
Could not
connect to remote server
”) occurs upon connecting to the web-based interface of the
extender
, make sure that you have properly connected the
extender
to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the
Figure 23. The page for running the Initial Configuration Wizard.
Page
32
of 125
