802.11 a/b/g Access Point Command Line Interface Manual
11
set dtim
Set Delivery Traffic Indication Message Beacon Rate. Default is 1
set dtim [1-255]
set fragmentthreshold
Set Fragment Threshold
set fragmentationthreshold [256-2346]
set rtsthreshold
Set RTS/CTS Threshold in bytes
set rtsthreshold [256-2346f]
set power
Set Transmit Power in predefined increments
set power [full:half:quarter:eighth:min]
set roguestatus
Set Rogue AP status
set roguestatus [enable:disable]
set roguebsstypestatus
Set Rogue AP BSS type status
set roguebsstypestatus [enable:disable]
set roguebsstype
Set ROGUE AP BSS Type
set roguebsstype [apbss:adhoc:both']
set roguesecuritystatus
Set Rogue AP Security Type status
set roguesecuritystatus [enable: disable]
set roguesecurity
Set ROGUE AP Security Type
set roguesecurity
set roguebandselectstatus
Set Rogue AP Band Select status set
roguebandselectstatus
[enable:disable]
set roguebandselect
Set ROGUE AP Band Select
set roguebandselect
set wlanstate
Select the operational state of wlan: enabled or disabled
set wlanstate [disable:enable]
set shortpreamble
Set Short Preamble
set shortpreamble [disable: enable]
set wirelessmode
set wirelessmode to 11b/11g.
set wirelessmode [11a:11b:11g]
NOTE:11a is not supported.
set 11gonly
Only 802.11g clients will be Allowed to connect to this BSS
set 11gonly [disable:enable]
set antenna
Set Antenna selection of 1, 2, or best
set antenna [1:2:best]
set aging
Set Aging Interval
set aging <seconds>
set channel
Select Radio Channel of Operation
set channel [1:2:3:4:5:6:7:8:9:10:11]
set eth2wlan
Enable or Disable the Eth2Wlan Broadcast packet filter feature
set eth2wlan [0:1]
Explanation: 0=disable:1=enable
set sta2sta
Set wireless STAs to wireless STAs connect state (WLAN Partition)
set sta2sta [disable: enable]
set eth2sta
Set ethernet to wireless STAs connect state
set eth2sta [disable: enable]
set trapsevers
Set trap server state
set trapsevers [disable:enable]
set MulticastPacketControl
Enable or Disable Multicast Packet Control
set MulticastPacketControl [0:1]
Explanation: 0=disable:1=enable
set
MaxMulticastPacketNumber
Set Max Multicast Packet Number
set MaxMulticastPacketNumber [0-1024]
set extendedchanmode
Set Extended Channel Mode
set extendedchanmode [disable:enable]
set eth2wlanfilter
Set Eth2WLAN Broadcast & Multicast Filter type
set eth2wlanfilter [1:2:3]
Explanation: 1=Broadcast filter: 2=Multicast filter: 3=Both of BC and
MC.
set ackmode
Set Ack Mode
set ackmode [enable:disable]
set acktimeout
Set Ack Timeout Number
set acktimeout <timeout>
set iapp
Set IAPP State.
set iapp [0:1]
Explanation: 0=close 1=open
set iappuser
Set IAPP User Limit Number
set iappuser [0-64]
