90
D-Link DIR-869 User Manual
Section 5 - Configuration - Extender Mode - Access Point
Configuration - Extender Mode - Access Point
Settings
Enter your password. If you previously followed the setup wizard, please use
the admin password you entered during the wizard. Otherwise, leave the
password blank. Click
Log In
to proceed.
Note:
If you cannot remember your password and cannot log in, press the reset/
wps button on the back of the device for longer than 10 seconds to restore the
router to its default settings.
To access the configuration utility, open a web-browser such as Internet
Explorer and enter
http://dlinkrouter.local./
or you may also connect by
typing the IP address* of the DIR-869 in the address bar.
* By default the DIR-869 in extender mode will use DHCP to obtain an IP address from
your uplink network. If you are using multiple DIR-869s or D-Link devices, go to
http://
dlinkrouterxxxx.local./
as
shown on the included Wi-Fi Configuration Card, with “xxxx”
being the last four digits of the DIR-869’s MAC address. The MAC address is also printed on
the label on the bottom of the device.
The Access Point's Wireless Settings page will open, allowing you to easily
adjust the wireless network settings.
The bar at the top of the page has quick access to the Home, Settings, and
Management functions.
Note:
The system will automatically log out after a period of inactivity.
