D-CUT MD-460, Руководство по эксплуатации

Страница: 3 / 6

3
CUTTING AND C
Installation
Install the table to
the cutter base with provided
screws and bolts as shown.
Then insert the handle into the
handle base as show and
tighten provided screw.
Warning:
Do not put your
fingers against the sharp edge
of the blade at any time.
45° Cutting
Adjust the angle attachment
to 45°. Insert material
between the cutting blade
and the base, against the
angle attachment as shown,
then push the handle down
to complete a cut.
Warning:
Maintain control
of the handle. Do not allow
handle to slam back after
making a cut.
Straight Cutting
Insert material between the
cutting blade and the base,
flush it with the guide bar as
shown and hold the material
then push handle down to
complete a cut.
Warning:
Maintain control of
the handle. Do not allow
handle to slam back after
making a cut.