13
EN / CZone® Control 1
4 INSTALLATION
THINGS YOU NEED
•
Control 1 Module & Top Cover (included)
•
Deutsch Connector Kit (included with part # 80-911-0119-00)
•
4 x 8G or 10G (4mm or 5mm) self-tapping screws or bolts for mounting Control 1 to surface
•
HDT-48-00 Deutsch crimp tool for crimping 0.5mm-4mm (20-12AWG) wire
•
Duratool D03008 crimp tool or similar for crimping 6mm (10AWG) wire (optional)
•
Appropriately rated ATC fuses for all circuits
•
NMEA2000 drop cable and T-connector
•
Screw driver and drill bits
•
Electrical Tools
Figure 5. Deutsch HDT-48-00 Crimp Tool
ENVIRONMENT
Obey the following stipulations during installation:
•
Ensure the Control 1 is located in an easily accessible location for quick access to fuses
•
Ensure indicator LED’s are visible for troubleshooting
•
Ensure circuit label is fitted and all channels labelled correctly
•
The Control 1 must be mounted at least 50mm away from high current carrying conductors such as anchor
winches, bow thruster cables, speakers, transformers and other high inductive loads.
•
Ensure Control 1 is mounted either vertically or horizontally
•
Ensure the bulkhead that the unit will be attached to is sufficiently strong to take the weight of the unit.
•
Ensure there is sufficient clearance above the Control 1 to allow the cover to be removed.
•
Ensure there is at least 10mm clearance around the sides and top of the Control 1
