EN / CZone® Waterproof Keypad User & Installation Manual
6
2 INSTALLATION
THINGS YOU NEED
•
Electrical Tools
•
2
1/16”
(52mm) hole saw
•
CZone Waterproof Keypad
•
Contact 6 PLUS or other CZone DC switching module
•
CZone Smart Harness or NMEA2000 network cables
MOUNTING
The CZone Waterproof keypad has been designed for the harsh marine environment, so they can be mounted to any
flat surface. The Waterproof Keypad’s are available in portrait and landscape orientation.
1. Drill the main hole with a 2 1/16” (52mm) hole saw
2. Drill the 4 corner screw holes
3. If using a custom configuration, loosen the dipswitch cover screws half a turn and slide dipswitch cover off and
set the dipswitch, refit the cover and tighten the screws
4. Install the dash gasket onto the keypad
5. Guide the harness through the hole and install the 4 corner screws
6. Install the appropriate circuit labels if using the retail keypad version
7. Fasten the Contact 6 PLUS by using 4 x 8G or 10G (4mm or 5mm) self-tapping screws or bolts (not supplied).
8. Install the bezel
9. Connect the network cable
