EN / CZone® Waterproof Keypad User & Installation Manual
10
ADDITIONAL FEATURES
The CZone waterproof keypad has some advanced functionality included which can be activated with some simple key
press combinations, see below.
2.5.1 Backlight Dimming
The Waterproof Keypad features backlit circuit labels for easy low light operation. You can
change the brightness level of the keypad by a short press on the power button. The backlight
will cycle through 4 preset brightness levels.
2.5.2 Backlight Color
The Waterproof Keypad uses RGB backlights allowing you to set your backlight to a color
that suits your install and use case. You can cycle through 12 preset colors by holding the
power button and repeatedly short pressing on button #1 or 2.
2.5.3 Momentary / Latching Switch Toggle
When installed with a Contact 6 PLUS any circuit can be toggled to operate as a
momentary circuit. This means the output channel is only on while you are pressing the
button, for example a horn circuit. You can toggle the operation of any circuit by push and
holding the power button and the desired circuit button at the same time for 5 seconds.
(Note, this functionality only works on a factory configuration).
2.5.4 Power Down / Sleep State
The CZone Waterproof Keypad and Contact 6 PLUS have an ultra-low current draw sleep state.
When you press and hold the power key for more than 3 seconds, all outputs on the Contact 6
PLUS will turn off and the system will go to sleep. Pressing the power button wakes the system
up again.
Short press
Long press
