4.4
Installing the cell holder
If UV Flow Cell, 2 mm or UV Flow Cell, 10 mm is to be used the flow cell holder included
in the Monitor UVis-920 delivery must be installed.
Follow the steps below to install the cell holder.
WARNING
High intensity UV light. This product uses high intensity ultra-
violet light. Do not disconnect the optical fibers while the lamp is
on.
NOTICE
To avoid damaging the optical inlet and outlet the two black rubber
caps at the optical fiber connectors must be in place when instal-
ling the cell holder.
Step
Action
1
Unpack the cell holder.
2
Slide the cell holder in place on the right hand side of the Monitor UVis-920
instrument.
4 Installation
4.4 Installing the cell holder
28
Monitor UVis-920 Operating Instructions 29055049 AF
