Cyrus Pre-XR
User Instructions
22
Remote control learning
In addition to controlling Cyrus components, the remote
control can learn the commands from two other remote
control handsets. These will normally be a TV and a
satellite or terrestrial TV receiver, programmed to the
‘TV’ and ‘SAT’ buttons, but could also be other audio
components.
All keys may be programmed with the exception of the
groups marked ‘CONTROL’ and ‘SOURCE’ and the ‘SETUP’
key.
Preparation for learning
Check the following points before attempting to learn any
commands -
•
Check that both remote controls have fresh batteries.
•
Choose a location on a tabletop that is not brightly lit.
Subdued light is better, away from bright natural or
indoor lighting.
•
Check that you have enough time to spare to complete
the learning process for all the keys you want to use.
Learning commands
In this example, the Cyrus remote control will be learning
commands from a ‘reference’ satellite receiver remote
control.
1. Set the two remote controls up facing each other,
spaced by about 5cm.
1
2
3
4
5
7
9
6
8
0/10
SAT
TV
STORE
MENU
ENTER
SELECT
LIST
CH
SETUP
abc
def
ghi
jkl
mno
pqrs
tuv
wxyz
GUIDE
INF
O
TEXT
TV/AV
CONTROL
SOURCE
1
2
3
4
5
7
9
6
8
0/10
SAT
TV
STORE
MENU
ENTER
SELECT
LIST
CH
SETUP
abc
def
ghi
jkl
mno
pqrs
tuv
wxyz
GUIDE
INF
O
TEXT
TV/AV
CONTROL
SOURCE
The keypad will light and the key you selected will be
red.
2. Press the ‘TV’
or ‘SAT’ key to
select the mode
that you want to
program.
3. Press and hold the
‘SETUP’ key.
The mode key will change to white. After about
three seconds, the mode key will light red again. This
indicates that the remote control is ready to learn
codes.
4. Release the ‘SETUP’ key.
The remote control is now waiting to learn commands.
The keypad will light continually and the mode key will
light pale red.
5. On the reference remote control, press and hold the
first key you want to learn (for example, volume up)
until the mode key flashes red.
This indicates that the command has been received.
6. Release the key on the reference remote control.
7. Press a key on the Cyrus remote control (volume up
in this example) to select where you want to save that
command.
The mode key will stop flashing. This indicates that the
command has been saved successfully.
If the learning process was successful, the remote
control will be ready to learn the next command.
8. Repeat steps 5 to 7 for each command you want to
learn.
When you have completed learning all commands -
•
Press the ‘SETUP’ key.
The mode key will change to white. After a few seconds
the backlight will switch off.
12
3
4
5
79
6
8
0/10
SA
T
TV
ST
ORE
MENU
ENTER
SELECT
LIST
CH
SETU
P
abc
def
ghi
jkl
mn
o
pqrs
tuv
wxyz
G
U
ID
E
IN
F
O
TEXT
TV/
AV
CONTRO
L
SOURCE
1
23
6
5
4
7
89
0
AUDI
O
SUB
TTX
GUIDE
FA
V
INFO
TV/
R
OK
LIST
EXI
T
AD
ZOOM
MENU
VOL
CH
5cm