CHAPTER3: Serial Programming Connection
1. Serial Programmer
P E R I P H E R A L M A N U A L
August 31, 2015, S6E1Cx_MN710-00016-1v0-E
45
CONFIDENTIAL
1.1. Basic Configuration
This section explains the basic configuration.
Basic Configuration of Cypress MCU Programmer (Clock Asynchronous Serial Write)
Cypress MCU Programmer writes data, through clock asynchronous serial communication, to
built-in flash memory of a microcontroller installed in the user system when the PC and the user
system are connected through RS-232C cable.
In these series, serial programming (UART communication mode) is possible by any clock,
crystal oscillator or built-in High-speed CR oscillator.
Figure 1-1 shows the basic configuration of Cypress MCU Programmer, and Table 1-1 lists the
system configuration.
Figure 1-1 Basic Configuration of Cypress MCU Programmer
Table 1-1 System Configuration of Cypress MCU Programmer
Name
Specifications
Cypress MCU Programmer
Software
(In case you request the data, contact to Cypress sales
representatives.)
RS-232C cable
Sold on the market.
In this series, serial wire debug terminals(SWDIO, SWCLK) are shared with serial writer
terminals(SIN0_0, SOT0_0). Therefore, both serial wire debugging and serial writing cannot be
used simultaneously.
*
RS-232C driver IC is required separately.
User system
*
RS-232C
