PSoC™ 6 Wi-Fi Bluetooth® pioneer kit guide, Document Number. 002-22677 Rev. *I
7
1.
Introduction
Thank you for your interest in the CY8CKIT-062-WIFI-BT PSoC™ 6 Wi-Fi Bluetooth
®
pioneer kit.
This kit enables you to evaluate and develop your applications using the
The PSoC™ 6 MCU is an ultra-low-power PSoC™ device specifically designed for wearables and
IoT products. It is a programmable embedded system-on-chip, integrating a 150-MHz Arm
®
Cortex
®
-M4 as the primary application processor, a 100-MHz CM0+ that supports low-power
operations, up to 1 MB flash and 288 KB SRAM, CAPSENSE™ touch-sensing, and programmable
analog and digital peripherals that allow higher flexibility, in-field tuning of the design, and faster
time-to-market.
The PSoC™ 6 Wi-Fi Bluetooth
®
pioneer board offers compatibility with shields compatible with
Arduino. The board features a PSoC™ 6 MCU, a 512-Mb NOR flash, an on-board programmer/
debugger (KitProg3), a 2.4-GHz WLAN and Bluetooth
®
functionality module (CYW4343W), a five-
segment CAPSENSE™ slider, two CAPSENSE™ buttons, one CAPSENSE™ proximity sensing
header, an RGB LED, two user LEDs, USB host and device features, and one push button. The
board supports operating voltages from 1.8 V to 3.3 V for the PSoC™ 6 MCU.
The kit package includes a CY8CKIT-028-TFT display shield that contains a 2.4-inch TFT display, a
motion sensor, ambient light sensor, a 32-bit audio codec, and a PDM microphone.
You can use ModusToolbox™ software to develop and debug your PSoC™ 6 MCU projects.
ModusToolbox™ software is a set of tools that enable you to integrate Cypress devices into your
existing development methodology.
If you are new to PSoC™ 6 MCU and Eclipse IDE for ModusToolbox™ software, see the application
note
AN228571 - Getting started with PSoC™ 6 MCU on ModusToolbox™ software
familiarize with the PSoC™ 6 MCU and help you create your own design using the ModusToolbox™
software.
