PSoC™ 6 Wi-Fi Bluetooth® pioneer kit guide, Document Number. 002-22677 Rev. *I
30
Kit operation
2.3
KitProg3: On-board programmer/debugger
The PSoC™ 6 Wi-Fi Bluetooth
®
pioneer kit can be programmed and debugged using the KitProg3
onboard programmer/debugger with USB-UART, USB-I2C, and USB-SPI Bridge functionality.
KitProg3 supports CMSIS-DAP and DAPLink mode for programming. A PSoC™ 5LP device is used
to implement the KitProg3 functionality. For more details on the KitProg3 functionality, see the
Note:
If you are using Rev *F or higher (see Kit Revision on the box), please note that the silkscreen
of the kit shows KitProg2 but KitProg3 is loaded on the kit.
2.3.1
Programming and debugging using ModusToolbox™ software
1. Connect the board to the PC using the provided USB cable through the KitProg3 USB connector,
as shown in
. It enumerates as a USB Composite Device if you are connecting it to
your PC for the first time.
2. The KitProg3 on this kit is in CMSIS-DAP Bulk mode by default. The status LED (amber), LED2
and power LED (amber), LED4 are turned ON at this time. If you do not see the desired LED
status, see the
for details on the KitProg3 status and troubleshooting
instructions.
Note:
Programming can be done in either KitProg3 programming modes, but it is recommended
to program the kit in CMSIS-DAP Bulk mode.
Figure 2-7. Connect USB cable to the USB connector on the board
