Cypress PSoC 5 FIRSTTOUCH CY8CKIT-014, Руководство пользователя

Страница: 11 / 44

CY8CKIT-014 PSoC 5 FirstTouch Starter Kit Guide, Spec. # 001-57708 Rev. ** 11
Installation
3. As specified, this installation process first determines if you have all prerequisite software. Follow
the on-screen dialogs to complete all required installations. After following these steps, you must
have the following software installed:
a. PSoC Creator 1.0
b. PSoC Programmer 3.11
c. GNU GCC Compiler (for PSoC 5 development)
d. PSoC 5 FirstTouch Starter Kit example projects and documentation
4. Following the software installation, verify you have all hardware and drivers setup for the PSoC 5
FirstTouch Starter Kit by connecting the kit board to your PC via its USB interface. As this is the
first time you have connected this board to this PC, initial driver installations occur. Should any
on-screen dialogs appear, follow them to complete the installation process.
Note After the installation is complete, the kit contents are found at the following location:
C:\Program Files\Cypress\PSoC 5 FirstTouch Starter Kit\
5. Now, verify your installation and setup by opening PSoC Programmer with the kit board attached
over USB. To open PSoC Programmer, click Start → Programs → Cypress → PSoC
Programmer 3.11 → PSoC Programmer (see Figure 3-4 ). In the port selection frame, you
should see the PSoC 5 FirstTouch starter kit. If you do, you have successfully installed all
required software and drivers to begin your PSoC 5 evaluation. Congratulations!
Figure 3-4. Opening PSoC Programmer
6. Close PSoC Programmer
7. Open PSoC Creator and continue on to the next section to experiment with the included example
projects.