Document Number: 002-04721 Rev.*A
Page 70 of 74
MB966B0 Series
Page
Section
Change Results
Changed the Value and condition of
“Power supply current for
active Low Voltage detector
”
I
CCLVD
Typ: 5μA, Max: 15μA, Remarks: nothing
→
Typ: 5μA, Max: -, Remarks: T
A
= +25°C
Typ: -
, Max: 12.5μA, Remarks: T
A
= +125°C
Changed the condition of
“Flash Write/Erase current”
I
CCFLASH
Typ: 12.5mA, Max: 20mA, Remarks: nothing
→
Typ: 12.5mA, Max: -, Remarks: T
A
= +25°C
Typ: -, Max: 20mA, Remarks: T
A
= +125°C
Changed the annotation *2
The power supply current is measured with a 4MHz external
clock connected to the Main oscillator and a 32kHz external
clock connected to the Sub oscillator.
→
When Flash is not in Power-down / reset mode, I
CCFLASHPD
must be added to the Power supply current.
The power supply current is measured with a 4MHz external
clock connected to the Main oscillator and a 32kHz external
clock connected to the Sub oscillator. The current for "On Chip
Debugger" part is not included.
44
3. DC Characteristics
(2) Pin Characteristics
Added the Symbol for High Drive type
V
OH20
, V
OL20
Added the Symbol for DEBUG I/F pin
V
OLD
45
3. DC Characteristics
(2) Pin Characteristics
Changed the Pin name of
“Input capacitance”
Other than
Vcc,
Vss,
AVcc,
AVss,
AVRH,
AVRL,
P08_m,
P09_m,
P10_m
→
Other than
C,
Vcc,
Vss,
AVcc,
AVss,
AVRH,
AVRL,
P08_m,
P09_m,
P10_m
Deleted the annotation
“I
OH
and I
OL
are target value.”
Added the annotation
“In the case of high current outputs, set “1” to the bit in the
Port High Drive Register.
”
