Page of
4
14
Quick-Start Guide
6 Connectors
Charger
HHR-RCHL
Handheld Rdr / Dock
(See pg. 1 for part #)
Reader Holster (opt.)
HHR-HOL3
Repeater
(opt.)
RPT-5651
Base Unit
HHR-6400
Warranty
(1) 12-pin
(1) 10-pin
(2) 8-pin
(2) 2-pin
Unpacking
• Remove packaging from units and check interior of Base Unit for any shipping damage.
• Inventory any included parts (depending on model).
HHR-3150 Series Base Unit Cable Recommendations
Wiegand and LED
PVC - Belden 9873 - 20 AWG 3 pair shielded, 500 feet max.
Plenum - Belden 83606 or 85164 - 20 AWG 3 pair shielded, 500 feet max.
Power (local)
PVC - Belden 8461 - 18 AWG 1 pair, 25 feet max.
Plenum - Belden 82740 - 18 AWG 1 pair, 25 feet max.
IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS For LiPo BATTERIES
It is important to specifically use a Lithium Polymer/Li-ion charger only. Do not use a NiMH or NiCd charger.
Failure to use the proper charger may cause a fire, which could result in personal injury and property
damage.
Never charge batteries unattended. When charging LiPo/Li-ion batteries, batteries should constantly be
observed to monitor the charging process to ensure batteries are being charged properly and to respond
to potential problems which may occur.
Some LiPo/Li-ion chargers on the market may have technical deficiencies and charge the LiPo/Li-ion
batteries incorrectly or at an improper rate. It is your responsibility to ensure the charger you purchased
works properly.
If at any time a battery begins to heat, smoke, swell, or balloon, immediately stop charging the battery and
disconnect the charger, then observe the battery in a safe place for approximately 15 minutes, since the
battery could leak and react with air, causing chemicals to ignite and result in a fire. Since delayed
chemical reaction can occur, it is best to observe the battery as a safety precaution, in a safe area outside
of any building or vehicle and away from any combustible material.
Program cards
(opt.)
HHR-CPC1/APC1