PSoC
®
Thermal Management Expansion Board Kit Guide, Doc. No. 001-89649 Rev. **
16
2.6 CY8CKIT-036 EBK Headers and Jumpers
The CY8CKIT-036 EBK provides numerous jumpers.
Table 2-3
lists the default jumper settings for the board.
Table 2-3. CY8CKIT-036 EBK Jumper Settings
Headers and
Jumpers
Description
Factory Default
Configuration
J1
Five-pin header for connecting an external host or management processor via
I2C/SMBus/PMBus.
Connector fitted
J2
Three-pin header to choose between a single-sensor or a dual-sensor (daisy chain)
connection for the PWM temperature sensors. Place the jumper in 1-2 position to enable
dual-sensor daisy-chain mode.
1-2 position (dual-sensor
daisy chain)
J3
J3 three-pin header to set logic signal levels for digital temperature sensors. Place in 1-2
position for 5-V interfacing; place in 2-3 position for 3.3-V interfacing.
2-3 position (3.3-V
interfacing )
J4
Four-pin header (1.25 mm pitch) to connect Fan 1. Supplies 12-V power, ground, PWM
drive, and tachometer feedback. All signals are replicated on J7.
Not connected
J5
Four-pin header (1.25 mm pitch) to connect Fan 2. Supplies 12-V power, ground, PWM
drive, and tachometer feedback. All signals are replicated on J8.
Not connected
J6
Four-pin header (1.25 mm pitch) to connect Fan 3. Supplies 12-V power, ground, PWM
drive, and tachometer feedback. All signals are replicated on J10.
Not connected
J7
Four-pin header (2.54 mm pitch) to connect Fan 1. Supplies 12-V power, ground, PWM
drive, and tachometer feedback. All signals are replicated on J4.
Connected to Fan 1
J8
Four-pin header (2.54 mm pitch) to connect Fan 2. Supplies 12-V power, ground, PWM
drive, and tachometer feedback. All signals are replicated on J5.
Connected to Fan 2
J9
Three-pin header for fan power supply. Place in 1-2 position to source external power
from the power jack (J13); place in 2-3 position to source 12-V power from the DVK.
1-2 position (fan power
from J13)
J10
Four-pin header (2.54 mm pitch) to connect Fan 3. Supplies 12-V power, ground, PWM
drive, and tachometer feedback. All signals are replicated on J6.
Not connected
J11
Four-pin header (2.54 mm pitch) to connect Fan 4. Supplies 12-V power, ground, PWM
drive, and tachometer feedback. All signals are replicated on J12.
Not connected
J12
Four-pin header (1.25 mm pitch) to connect Fan 4. Supplies 12-V power, ground, PWM
drive, and tachometer feedback. All signals are replicated on J11.
Not connected
J13
Power jack. 12-V DC nominal.
Connector fitted
J14
2×20 pin header for connecting to the PSoC DVK.
Connector fitted
J15
2×20 pin header that replicates signals on J14 for easy connection to a logic analyzer or
oscilloscope.
Open
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
