Cypress CY4603, Руководство пользователя, Страница: 23 / 94

HX3 Kits User Guide, Doc. #: 001-91203 Rev. *D 23
Kit Operation
Figure 3-9. CY4613 Jumper Block Layout
3.4 Operating the Kits
The following sections explain the procedure to operate the kits. These steps are based on CY4609
and they are applicable to CY4603 and CY4613 as well. Unique steps for each kit are specified in
the corresponding sections.
3.4.1 Powering the Kit
1. Unpack the power adapter, USB 3.0 cable, and HX3 board from the kit package.
2. Ensure that the Configuration Mode Selection jumper blocks for firmware are set to Custom Firm-
ware, as shown in Table 3-4 .
3. Plug the power adapter into an AC wall power receptacle. Connect the power supply plug to the
board's DC supply jack. The power (PWR) LED glows green to indicate that the board is pow-
ered. The SUSP LED glows amber to indicate that HX3 is in Suspend mode because it is not
connected to a PC on the upstream port, as shown in
Figure 3-10 .
Table 3-4. Configuration Mode Selection Settings
Kit
Custom Firmware (Default
Factory Setting)
ROM Firmware
CY4609
J6: Short pins 1 and 2
J7: Short pins 2 and 3 J6: Short pins 1 and 2
J7: Short pins 1 and 2
CY4603
J17: Short pins 1 and 2
J18: Short pins 2 and 3 J17: Short pins 1 and 2
J18: Short pins 1 and 2
CY4613
J5: Short pins 1 and 2
J6: Short pins 2 and 3 J5: Short pins 1 and 2
J6: Short pins 1 and 2
Pin 1
Pin 2
Pin 3
Pin 1
Pin 2
Pin 3
Pin 2
Pin 3
Pin 1
Pin 4
3-pin Jumper Block (horizontal type)
3-pin Jumper Block (vertical type)
4-pin Jumper Block