CY3274 Cypress High Voltage Programmable PLC Development Kit Guide, Doc. # 001-53598 Rev. *G
65
Code Examples
Example project with this functionality is present in present inside the firmware folder of the kit
installation.
5.3.1
Software Requirements
To use the PLT User Module, you must have the following software installed:
■
http://www.cypress.com/psocdesigner
)
■
PSoC Programmer 3.20.1 or higher (
http://www.cypress.com/go/psocprogrammer
)
■
http://www.cypress.com/?rID=38135
)
5.3.2
PLT Configuration
You can either follow the below steps for developing the project for I
2
C interface with PLC or you can
directly use the “CY3274_PLC_Control_Panel” project present in the Firmware folder of the CY3274
kit installation location. The “CY3274_PLC_Control_Panel” project has been created by following the
below procedure.
Follow these steps to set up the PLT UM with I
2
C interface:
1. Place the PLT UM and Select the “FSK Modem + Network Stack + I2C Bridge” option as shown in
.
Figure 5-13. Select Option “FSK Modem + Network Stack + I
2
C Bridge”
Содержание CY3274
Страница 74: ...74 CY3274 Cypress High Voltage Programmable PLC Development Kit Guide Doc 001 53598 Rev G A 2 2 Ground Layer ...
Страница 75: ...CY3274 Cypress High Voltage Programmable PLC Development Kit Guide Doc 001 53598 Rev G 75 A 2 3 Power Layer ...
Страница 76: ...76 CY3274 Cypress High Voltage Programmable PLC Development Kit Guide Doc 001 53598 Rev G A 2 4 Bottom Layer ...
Страница 77: ...CY3274 Cypress High Voltage Programmable PLC Development Kit Guide Doc 001 53598 Rev G 77 A 2 5 Top Silkscreen ...
