Cypress CY15FRAMKIT-002, Руководство пользователя, Страница: 6 / 34

CY15FRAMKIT-002 DVK, Doc. No. 002-23147 Rev. ** 6
2.2 Kit Introduction and Configuration Guide
The following sections describe various aspects of the kit hardware and the kit setup.
2.2.1 F-RAM Device Power Supply Jumper
The CY15FRAMKIT-002 Board hardware operates at 1.8 V/3.3 V, selected through header J5, as shown in Figure 2 .
The factory default jumper setting is 3.3 V (short pins 3 and 4 of J5). User can short the pins 1 and 2 of J5 for 1.8 V
selection.
CAUTION
▪
Do not power the CY15FRAMKIT-002 board through an external power source. The board is designed to be
powered by the ST NUCLEO-L433RC-P MCU Evaluation base board.
▪
The CY15FRAMKIT-002 operates from 1.8 V to 3.6 V. Exceeding the maximum voltage limit (3.6 V) can damage
the board.
Figure 2. F-RAM Device VDD Select Jumper
2.2.2 ST Controller Device Power Supply Jumper
The ST NUCLEO-L433RC-P MCU Evaluation Board hardware operates at 1.8 V/3.3 V, selected through header J6,
as shown in
Figure 3 . The factory default jumper setting is 3.3 V (short pins 3 and 4 of J6). User can short the pins 1
and 2 of J6 for 1.8 V selection
.
CAUTION
▪
Do not power the ST
NUCLEO-L433RC-P MCU Evaluation
board through an external power source. The
board is designed to be powered by the Regulator output on the
board.
▪
The
ST
NUCLEO-L433RC-P MCU Evaluation operates from 1.8 V to 3.6 V. Exceeding the maximum voltage limit
(3.6 V) can damage the board.
Figure 3. ST Controller Device VDD_M Select Jumper