Kit Operation
CY4701 EZ-
USB® GX3™ Reference Design Guide Doc. No. 001-97892 Rev. **
9
For more information, refer to
A.1 Installing and Binding the Driver Manually
Figure 3-2. Folder for cyusb3610 Driver
Note:
If a "Welcome to the Found New Hardware Wizard" message appears, select the
Yes, this time only
option and
click
Next
to continue the installation.
3. When the software drivers are successfully bound, the board enumeration is complete. The board appears as a
network adapter in the Windows
Device Manager
.
To launch the
Device Manager
in Windows 7, go to
Start
>
Control Panel
>
Device Manager
Figure 3-3. CY4701 RDK Enumeration as a Network Adapter in Device Manager
3.2 Testing CY4701 RDK Functionality
You can perform the EZ-USB GX3 functionality and performance tests using a software PC tool,
iperf.exe
.
Iperf is an open
source tool to measure maximum TCP bandwidth, allowing you to tune various parameters and UDP characteristics. Iperf
Follow these steps to test the
dongle’s functionality using the Iperf
test tool:
1. Connect the CY4701 RDK dongle to the USB port of the PC. This PC will act as a client PC.
2. Connect an Ethernet cable to the RJ45 connector of the CY4701 RDK to the Ethernet port of the other PC. This PC will
act as server PC.
3. On the server PC, go to
Computer
>
Network
>
Network and Sharing Center
.