Cypress Semiconductor CY8CKIT-003, Руководство пользователя

Страница: 11 / 42

CY8CKIT-003 PSoC 3 FirstTouch Starter Kit Guide, Spec. # 001-49613 Rev. *B 11
Installation
d. GNU GCC Compiler (for PSoC 5 development)
e. PSoC 3 FirstTouch Starter Kit example projects and documentation
4. Following the software installation, verify you have all hardware and drivers setup for the PSoC 3
FirstTouch Starter Kit by connecting the kit board to your PC via its USB interface. As this is the
first time you have connected this board to this PC, initial driver installations occur. Should any
on-screen dialogs appear, follow them to complete the installation process.
5. Now, verify your installation and setup by opening PSoC Programmer with the kit board attached
over USB. To open PSoC Programmer, click Start → Programs → Cypress → PSoC
Programmer 3.10 → PSoC Programmer (see Figure 3-4 ). In the port selection frame, you
should see the PSoC 3 FirstTouch starter kit. If you do, you have successfully installed all
required software and drivers to begin your PSoC 3 evaluation. Congratulations!
Figure 3-4. Opening PSoC Programmer
6. Close PSoC Programmer
7. Open PSoC Creator and continue on to the next section to experiment with the included example
projects.
Figure 3-5. Opening PSoC Creator
Downloaded from Elcodis.com electronic components distributor