CYP PUV-1830TX-AVLC, Руководство по эксплуатации, Страница: 9 / 23

9
6.2 Rear Panel
CAT5e/6/7 OU T HQ / ST D
SWITCH
HQ
STD
HDMI IN LAN
1 2 3 4 5
1
LAN:
Connect to an Ethernet supporting device or to your local
network, as appropriate, to extend the network to both ends of the
HDBaseT connection.
2
HDMI IN:
Connect to HDMI source equipment such as a media player,
game console or set-top box.
3
HQ & STD LEDs: These LEDs illuminate to indicate which AVLC mode
will be used when AVLC is required. The lower green LED indicates that
AVLC will use HQ (High Quality) mode. The upper yellow LED indicates
that AVLC will use STD (Standard) mode.
4
HQ/STD SWITCH:
This switch allows the user to select which
compression mode to use when AVLC is active, High Quality or
Standard.
Note: HQ (High Quality) mode uses the least amount of compression
and provides the highest possible visual quality (perceptually identical
to the original). STD (Standard Quality) mode applies additional signal
reduction methods to lower the bandwidth requirements of 4K sources
further, improving transmission reliability over longer cable runs at the
cost of some visual fidelity.
5
CAT5e/6/7 OUT: Connect to a compatible HDBaseT Receiver with a
single Cat.5e/6/7 cable for transmission of all data signals. 48V PoH
will also be supplied when connected to a compatible PD Receiver.
Note: The 48V PoH function is designed for powering compatible Receiver
units only. Non-PoH Receivers will need their own power supply. Receivers
from other brands may not be compatible.