8
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Receiver Front and Rear Panels
RS-232 Out
LAN
HDMI Out
Receiver
Rear
Front
CAT5e/6 In
Link
IR1 Extender
IR2 Blaster
Power
DC 24V
2
3
1
7
4
8
9
6
5
1
HDMI Out:
Connect to a HDMI equipped TV/monitor for display of the
HDMI input source signal.
2
LAN:
Connect to a PC or Laptop to the Internet or network connection.
3
RS-232 Out:
Connect to the device that is to be controlled (via D-Sub
9 pin female cable) by RS-232 commands.
4
Power LED:
This blue LED will illuminate when the device is connected
to a power supply.
5
DC 24V:
Plug the 24 V DC power supply into the unit and connect
the adaptor to an AC outlet. Only one side of power needs to be
connected to activate both transmitter and receiver.
6
IR 2 Blaster:
Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line of sight of the
equipment to be controlled.
7
IR 1 Extender:
Connect to the supplied IR receiver cables for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR extender.
8
Link LED:
The yellow LED will illuminate when both the input and
output signals are connected.
9
CAT5e/6 In:
Connect to the transmitter unit with a Single CAT5e/6
cable for transmission of all data signals.
