CYP PU-507TX-HDVGA, Руководство по эксплуатации, Страница: 9 / 21

9
6.2 Rear Panel
IR
Blaster
IR
Extender
CAT5e/6/7 OUT
MODE LINK
LAN RS-232 IN
DC 24V
POWER
1 2 3 4 5 6 8 9 7
1
Power LED:
This LED will illuminate when the device is connected
with power supply.
2
DC 24V:
Plug the 24 V DC power supply into the unit and connect the
adaptor to an AC outlet. Only one side of power is needed to activate
both Transmitter and Receiver when both obtain the PoE function.
3
RS-232 IN:
Connect to a PC or Laptop with D-Sub 9-pin male cable to
bypass RS-232 commands to the Receiver, or for direct RS-232 control
of the PU-507TX-HDVGA.
4
LAN:
Connect to an active network for LAN sharing of a total
transmission rate up to 100Mbps. Or when a compatible LAN
equipped Receiver is connected to an active network, this allows
the network access (including internet access if available) to be
shared between the Transmitter and Receiver. Connect any Ethernet
equipped device e.g. a Smart TV or games console to the LAN port for
that device to share the network internet access.
Note: DO NOT connect this slot with any of the CAT5e/6/7 port. Doing so
may trigger power shut down and ruin the device.
5
IR Blaster:
Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
6
IR Extender:
Connect to the supplied IR Receiver cables for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR Extender.
7
MODE LED:
This LED will illuminated when the power is connected.
8
Link LED:
This LED will illuminate when the slot has been connected
to the Receiver and the Receiver has connected with display that
shows image on screen.
9
CAT5e/6/7 Out:
Connect to the Receiver unit with a single CAT5e/6/7
cable for transmission of all data signals.