9
6.2 Rear Panel
POWER
DC 24V
CAT5e/6 OUT
IR 1
BLASTER
USB
LINK
IR 2
EXTENDER
1
2
3
4
5
6
7
1
POWER LED:
Once the power supply is connected the LED will
illuminate.
2
DC 24V:
Plug the 24V DC power supply into the unit and connect the
adaptor to an AC outlet.
3
IR 1 BLASTER:
Connect with the supplied IR Blaster to blast out the
IR signal received from the Receiver side. Place the IR Blaster in direct
lineof-sight of the equipment to be controlled.
4
IR 2 EXTENDER:
Connect with the supplied IR Extender to receive IR
signal from Transmitter side and blast out at Receiver side. Ensure that
remote controller being used is within the direct line-of-sight of the IR
Extender.
5
USB:
This slot is reserved for firmware update only.
6
LINK:
This LED will illuminate when CAT5e/6/7 output have been
connected to the Receiver and the Receiver have connected with
display that shows image on screen.
7
CAT5e/6/7 OUT:
Connect this port to CAT5e/6/7 to HDMI Receiver
with CAT5e/6/7 cable to extend the signal up to 100m.