9
6.2 Rear Panel
IR A1
Extender
IR B1
Extendrt
IR A2
Blaster
IR B2
Blaster
LAN
T
U
O
6
/
e
5
T
A
C
T
U
O
6
/
e
5
T
A
C
MODE
LINK
B
A
MODE
LINK
2
1
3 4
6
4
6
2
5
3
5
1
LAN:
Connect to an active network for LAN serving. When any
compatible LAN equipped receivers are connected, this allows the
network access (including internet access if available) to be shared
between any connected LAN equipped receivers. Connect any
Ethernet equipped device e.g. a Smart TV or games console to the
LAN port of a receiver for that device to share the network/internet
access.
2
IR A1/B1 IR Extender:
Connect the IR extenders for IR signal reception
. Ensure that the remote being used is within the direct line-of-sight of
the IR extender.
3
IR A2/B2 IR Blaster:
Connect to the IR blasters for IR signal
transmission. Place the IR blaster in direct line-of-sight of the
equipment to be controlled. Use the supplied IR 'Y' Cable to ensure
control from each HDBaseT zone.
4
MODE LED:
When the device is powered the LED will flash.
5
CAT5e/6 OUT A & B:
Connect to HDMI to CAT5e/6/7 receivers (with or
without PoE function) with CAT5e/6/7 cable to extend the signal up to
100m.
NOTE: Non PoE receivers will require their own power supply
6
LINK LED:
When the device is powered on and this slot is connected
to a compatible receiver device with CAT5e/6/7 cable the LED will
illuminate.
