CYP CRS-232, Руководство по эксплуатации

Страница: 5 / 8

6. Operation Controls and Functions
6.1 TX Front Panel TX Rear Panel
①
RS-232 IN
② ③
CAT5
DC 5V
q
Connect a PC/laptop‘s main control system with a DB 9 female to male
cable in order to send protocol to the source device.
②
Connect a CAT 5 cable up to 250M away and link it to the Receiver.
③
Connect the 5V DC power adaptor into the unit and plug the adaptor
into an AC outlet.
Note: Only one adaptor is needed for both the Transmitter and Receiver.
6.2 RX Front Panel RX Rear Panel
①
CAT5
DC 5V
② ③
RS-232 OUT
①
Connect the CAT 5 cable from the Transmitter into the Receivers CAT 5
slot.
②
Connect the 5V DC power adaptor.
Note: Only one adaptor is needed for both Transmitter and Receiver
however, if operating at extreme distances or if no image is
displayed then two adaptors will be required.
③
Connect to the source device with a DB 9 male to female cable for
receiving and communicating with a PC/Laptop.
2