CYP CMSI-424E, Руководство по эксплуатации, Страница: 9 / 20

4
6.2 Rear Panel
1
IR IN IR OUT
2
IR IN IR OUT
3
IR IN IR OUT
4
IR IN IR OUT
HDMI OUT CAT5e/6 OUT
A
CAT5e/6 OUT
B
HDMI OUT CAT5e/6 OUT
C
CAT5e/6 OUT
D
HDMI IN 1 HDMI IN 2 HDMI IN 3 HDMI IN 4
DC 24V
1 2
3 4
V+
GND
GND GND
V+
IR OUT
IR IN
ALL
SERVICE
RS232
IP &
ETHERNET
2 3
5
11 10
1
4
8 6
7 9
1
RS-232: Connect to a PC or control system with D-Sub 9-pin cable
for the transmission of RS-232 commands.
2
IP & ETHERNET: Connect to an active network for LAN serving and
Telnet/Web GUI control (refer to Sections 6.8 and 6.9).When the
Matrix or any compatible LAN equipped receivers are connected
to a network, this allows the network access (including internet
access if available) to be shared between the Matrix and all
connected LAN equipped receivers. Connect any Ethernet
equipped device such as a Smart TV or games console to the LAN
port of a receiver for that device to share the network/internet
access.
Warning: Please do not connect this port directly to the PC/Laptop
as the Telnet function will not work.
3 SERVICE: Manufacturer use only.
4
HDMI OUT and CAT5e/6/7 OUT A/C: Simultaneous HDMI and
HDBaseT CAT5e/6/7 output. The HDMI output can be connected
directly to a display or to a point transmitter/receiver set. Connect
the CAT5e/6/7 output to a compatible receiver unit to extend the
signal up to 100 m.
5
CAT5e/6/7 OUT B/D: Connect from these CAT outputs to the CAT
input port of the receiver units with a single CAT5e/6/7 cable for HDMI
Audio/Video and IR/RS-232 control signal transmission.
Warning: Please do not connect the CAT5e/6/7 output into the
receiver's LAN port.
6 HDMI IN 1~4: Connect to the HDMI input source devices such as a
DVD player or a Set-top Box with HDMI cable or DVI to HDMI cable.
7
IR IN 1~4: Connect the IR extenders for IR signal reception. Ensure
that the remote being used is within the direct line-of-sight of the IR
extender.