CYP CH-352TX, Руководство по эксплуатации, Страница: 18 / 36

13
1) Video over IP: This section allows control over the streaming bit rate
and transmission quality.
„
Maximum Bit Rate: Set the maximum bit rate that can be used by
the output video stream. Available options are: Unlimited, 400 Mbps,
200 Mbps, 100 Mbps, 50 Mbps. Selecting “Unlimited” will use up to
the maximum available bandwidth in order to maintain a full framerate
video stream.
„
Maximum Frame Rate: Adjusting this slider will set the percentage
of frames from the source video to encode (2–100%). This is ideal for
reducing the bandwidth requirements of high-resolution, but limited
motion, sources such as slide presentations or information screens.
Note: If the framerate is lowered too far with motion video sources, the
video will become noticeably choppy.
2) Audio over IP (Transmitter 1 Only): The audio source to embed in
the transmitter’s outbound AVoIP stream is selected here. Selecting
“HDMI” will always embed HDMI 1’s audio source, selecting “Line In” will
always embed the Line In audio source, selecting Auto will embed audio
according to the default routing behavior (see section 8.3.3).
3) Serial over IP (Transmitter 1 Only): This section provides controls for
the serial over IP extension functionality, including setting the RS-232
data configuration.
„
Serial Settings: Set the desired baud rate, data bits, parity, and stop
bit for the RS-232 signal to extend.
Note: The transmitter and receiver must have the same serial settings.
4) Reboot: Pressing this button will force the unit to reboot.