CYP CH-306TXA & RXA, Руководство по эксплуатации, Страница: 8 / 16

4
7. OPERATION CONTROLS AND FUNCTIONS
7.1 Transmitter’s Front Panel
2 3 4 5 6
POWER RS232 IN
IR
BLASTER
LINK
PAIR SEL
LINK
HDMI / USB / IR / RS232 TO CAT5e/6 TRANSMITTER
1
1 USB LED
This LED will illuminate when the transmitter has linked with
receiver's USB signal. User are only able to control the USB in (the
source device) when this LED is not illuminated.
2 LINK LED
This LED will illuminate when the transmitter is linked with receiver's
signal.
3 RS 232 IN
This slot is to connect with D-Sub 9pin female null moden cable
from PC’s system for controlling both the input source and output
display over RS-232.
4 IR BLASTER
This slot is to connect with IR blaster cable included in the package
for IR signal sending and controlling the HDMI input source
equipment.
5 IR
This IR reciever can accept IR signal of the HDMI input source
device with frequency between 20~60Hz and can send the
signal over CAT5e/6 to transmitter side to control the input source
equipment.
6 LINK PAIR SELECT
This dip switch allows user with matrix setting for link up to 16 pairs
of the devices with single IP router. Each pair must have the same
dip switch setting in order to pair to the right device setting. The
factory default setting is at 0000.