CYP CH-1529RXV, Руководство по эксплуатации

Страница: 9 / 20

4
5 SERVICE: This USB port is reserved for firmware update.
6
RS-232: Connect to a PC, laptop or other serial control device
with a 3-pin adapter cable for the extension of RS-232 signals to
the Transmitter in "Bypass" mode, or for control this unit when in
"Console" mode.
Note: Depending on the controlled device connected to the
Transmitter side, the Tx and Rx pins might need to be reversed.
7
CONSOLE/BYPASS: This switch controls the operational mode of the
RS-232 port. When set to “Bypass”, RS-232 signals will be passed to
the connected Transmitter. When set to “Console” the RS-232 port
may be used to send commands directly to the Receiver.
Note: RS-232 bypass requires both the Transmitter and Receiver to
be set to “Bypass” mode.
6.2 Rear Panel
CAT5e/6/7 IN HQ
STD
HDMI OUT LAN
1 3 2 4
1
LAN: Connect to an Ethernet supporting device or to your local
network, as appropriate, to extend the network to both ends of
the HDBaseT connection.
2 HQ & STD LEDs: These LEDs illuminate to indicate which AVLC mode
will be used when AVLC is required. The lower green LED indicates
that AVLC will use HQ (High Quality) mode. The upper yellow LED
indicates that AVLC will use STD (Standard) mode.
3
HDMI OUT: Connect to an HDMI TV, monitor or amplifier for digital
video and audio output.
4
CAT5e/6/7 IN: Connect to a compatible, 48V PoH supplying,
HDBaseT Transmitter with a single Cat.5e/6/7 cable for transmission
of all data signals as well as to power the unit.