CYP CH-1527RX, Руководство по эксплуатации, Страница: 8 / 16

3
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
POWER
LINK
RS-232 IN
STD UPDATE
LAN
6 7 8 10 9
CAT5e/6/7 OUT
IR2
EXTENDER
HDMI IN
DC 48V
IR1
BLASTER
1 3 4 5 2
Rear Front
1 DC 48V: Plug the 48V DC power supply into the unit and connect
the adaptor to an AC outlet.
2 IR1 BLASTER: Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
3 IR2 EXTENDER: Connect to the supplied IR Extender cables for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
4 CAT5e/6/7 OUT: Connect to the Receiver unit with a single
CAT5e/6/7 cable for transmission of all data signals.
5 HDMI IN: Connect to HDMI source equipment such as a DVD or
Blu-ray player.
6 STD/UPDATE Switch: This switch is reserved for factory use only.
7 RS-232 IN: Connect to a PC or Laptop with D-Sub 9-pin male cable
for the transmission of RS-232 commands.
8 LAN: Connect to an internet or network system.
9 POWER LED: This LED will illuminate when the device is connected
to a power supply.
10 LINK LED: This LED will illuminate when both Transmitter and Receiver
are connected through CAT cable. When it blinks regularly it
states the Transmitter is NOT sending signal but the Transmitter and
Receiver are linked and if it blinks irregularly it states an error has
occurred.