4
6.2 Receiver Front and Rear Panels
RS-232 OUT
LAN
HDMI OUT
CAT5e/6/7 to HDMI with LAN/IR/RS-232
Receiver
CAT5E/6/7 IN
LINK
IR1
EXTENDER
IR2
BLASTER
POWER
Rear
Front
2
3
1
6
5
7
8
4
1
HDMI Out: Connect to a HDMI equipped TV/monitor for display of
the HDMI input source signal.
2
LAN: Connect to a PC or Laptop to the Internet or network
connection.
3
RS-232 Out: Connect to the device that is to be controlled (via
D-Sub 9 pin female cable) by RS-232 commands.
4
Power LED: This blue LED will illuminate when the device is
connected to a power supply.
5
IR 2 Blaster: Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line of sight of the
equipment to be controlled.
6
IR 1 Extender:
Connect to the supplied IR Extender cables for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
7
Link LED: The yellow LED will illuminate when both the input source
and output display signals are connected through CAT cable.
When it blinks regularly it states the display is NOT sending signals to
receiver but the transmitter and receiver are linked and if it blinks
irregularly it states and error has occurred.
8
CAT5e/6/7 In: Connect to the Transmitter unit with a Single
CAT5e/6/7 cable for transmission of all data signals.
