CYP CH-1109RX, Руководство по эксплуатации, Страница: 9 / 16

4
6.2 Receiver Front and Rear Panels
LAN 2 LAN 3 LAN 1
IR 2
Blaster
IR 1
Extender DC 48V
RS-232
Out
Power
HDCP
Link
Mode
CAT5e/6
In
CAT5e/6 to HDMI with LAN/PoE/IR CH-1109RX Receiver
HDMI
Out
Rear Front
7
6 5 4 3 2 1 8 9 10 11
1
Power LED: The LED will illuminate in red when the 48 V DC power
supply is connected to the AC outlet.
2
DC 48V: Plug the 48 V DC power supply into the unit and connect
the adaptor to an AC outlet.
3
IR 1 Extender: Connect to the supplied IR extender cable for IR
signal reception. Ensure that the remote being used is within the
direct line-of-sight of the IR extender .
4 IR 2 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line-of-sight of the
equipment to be controlled.
5
RS-232 Out: Connect to a PC/Laptop or RS-232 enabled device
with a D-Sub 9-pin cable for the transmission of RS-232 commands.
5
Link LED: The Link LED will illuminate in yellow when the both the
Transmitter and Receiver are properly connected and data is
being transmitted/received.
6 HDCP LED: The HDCP LED will illuminate in red when the input
source signal contains HDCP data.
7
Mode LED: The Mode LED flash green when the device is
processing data.
9
CAT5e/6 In: Connect to the Transmitter unit with a single CAT5e/6
cable for the transmission of all data signals.
12
HDMI Out: Connect to an HDMI equipped TV/monitor for display of
the HDMI input source signal.
13
LAN 1/2/3: The LAN connections can be used to connect and
share up to 6 Ethernet connections (3 at the Receiver end, 3 at the
Transmitter end), including computers, routers and media servers.